Welcome Guest Login or Signup
SureBaby  

General Discussion | Introduction and features of Peanut Thresher with


Bookmark:
RSS 1.0     RSS 2.0
Total Views: 25 - Total Replies: 0

POSTED BY: yanghm on 05/16/2019 06:02:15
Peanut Thresher is a successful development of Aike Machinery. The product has the characteristics of small size, convenience, lightweight, easy to move, simple installation, high production efficiency, low cost, and good cleaning effect. Aike Machinery Wholesale Peanut Thresher with Dust Removal Sheller. A Peanut Thresher with Dust Removal Sheller is a machine that removes the peanut shell by rotating the body at a high speed and keeps the peanut intact. 1. The shelling is clean and the productivity is high. For the shelling machine with the cleaning device, high cleanliness is also required. 2. The loss rate is low and the breakage rate is small. 3 Simple structure, reliable use, convenient adjustment, low power consumption, certain versatility, can take off a variety of crops, to improve the utilization of machinery. 2. Requirements for peanuts (pectin). Peanuts are suitable for dry and wet, too dry, the rate of breakage is high and too wet will affect work efficiency. Peanuts (fruits) stored in rural areas are generally dry, and the following methods are suitable for drying and drying. 3, shelling in winter, sprayed with 50 kilograms of warm water evenly on the 50 kilograms of peeled fruit before shelling, and covered with plastic film for about 10 hours, then drying in the sun for about 1 hour to start shelling, other seasons The plastic film covers the time of about 6 hours, and the rest is the same. 4. Dilute the dried peanuts (pectin) in a large pool. Immediately after soaking, remove and cover with plastic film for about 1 day, then dry in the sun. After drying and drying, start shelling. 5. Requirements for voltage and choice of workplace. The single phase should work normally and the voltage must reach its rated voltage. In rural areas, there is only one transformer in a village, and the households are scattered. In addition, the wires and circuits used are not very standard, resulting in insufficient voltage for users far from the transformer. Therefore, the workplace should be close to the transformer.
07/18/2019


Quantcast